Table of Contents
Advertisement
MANUAL TRANSMISSION AND DIFFERENTIAL
23) Using the pinch bar, remove the left and right
front drive shaft from transmission.
(A) Pinch bar
24) Remove the nuts which hold lower side of
transmission to engine.
25) Place the transmission jack under transmis-
sion.
CAUTION:
Always support transmission case with a trans-
mission jack.
Manual Transmission Assembly
(A)
MT-01017
MT-00077
MT-00078
5MT-32
26) Remove the transmission rear crossmember
from vehicle.
27) Remove the transmission.
NOTE:
Move the transmission jack toward rear until main
shaft is withdrawn from clutch disc.
28) Separate the transmission assembly from rear
cushion rubber.
B: INSTALLATION
1) Install the rear cushion rubber to transmission
assembly.
Tightening torque:
⋅
35 N
m (3.6 kgf-m, 26 ft-lb)
2) Install the transmission onto engine.
(1) Gradually raise the transmission with trans-
mission jack.
(2) Engage them at splines.
NOTE:
Be careful not to strike the main shaft against clutch
housing cover.
3) Install the transmission rear crossmember.
Tightening torque:
⋅
T1: 70 N
m (7.1 kgf-m, 51.6 ft-lb)
⋅
T2: 140 N
m (14.3 kgf-m, 103 ft-lb)
T 1
T 2
4) Take out the transmission jack.
MT-00079
T 1
T 2
MT-00081
Advertisement
Chapters
Table of Contents
