Subaru Legacy 2005 Service Manual page 2850

FRONT SUSPENSION
6. REAR WHEEL TOE-IN
• INSPECTION
Toe-in:
± ±
0 3 mm (0 0.12 in)
Refer to "FRONT WHEEL TOE-IN" for rear toe-in
inspection procedure.
<Ref. to FS-11, FRONT WHEEL TOE-IN, INSPEC-
TION, Wheel Alignment.>
• ADJUSTMENT
When adjusting, adjust it to the following value.
Toe-in:
± ±
0 2 mm (0 0.08 in)
Rotate the left side clockwise.
Rotate the left side counterclockwise.
Wheel Alignment
1) Loosen the self-locking nut on the inner side of
rear link.
NOTE:
When loosening or tightening the adjusting bolt,
hold the bolt head and turn self-locking nut.
2) Turn the adjusting bolt until toe-in is at the spec-
ification.
NOTE:
When the left and right wheels are adjusted for toe-
in at the same time, the movement of one scale
graduation changes toe-in by approx. 0.6 mm (0.02
in).
To increase toe-in.
FS-00018
To decrease toe-in.
FS-00019
FS-12
(1)
(1) Adjusting bolt
(2) Rear link
Rotate the right side counterclockwise.
Rotate the right side clockwise.
(2)
FS-00103
FS-00019
FS-00018