Subaru Legacy 2005 Service Manual page 2145

2. SIDE RETAINER
NOTE:
After adjusting the drive pinion backlash and tooth
contact, remove and install the oil seal and O-ring.
1) Remove the O-ring.
2) Remove the oil seal.
3) Remove the split pin, and then remove the claw.
ST 398527700 PULLER ASSY
(A) Claw
(B) Split pin
(C) Pin
Front Differential Assembly
4) Attach two claws to the outer race, and set the
ST to side retainer.
ST 398527700
AT-00219
5) Attach the removed claws to original position,
and install the pin and split pin.
6) Hold the shaft of ST to avoid removing from side
retainer, and then remove the bearing outer race.
ST 398527700
NOTE:
Replace the bearing inner and outer races as a sin-
gle unit.
AT-00220
AT-00221
4AT-117
AUTOMATIC TRANSMISSION
PULLER ASSY
(A) Shaft
(B) Claw
PULLER ASSY
(A) Shaft
(B) Side retainer
AT-00222
AT-00223