Table of Contents
Advertisement
7) Pull the piston rod fully upward, and install the
spring seat.
NOTE:
Ensure the upper spring seat is positioned as
shown in the figure.
(1) Outside of body
8) Install the strut mount to piston rod, and tempo-
rarily tighten a new self-locking nut.
9) Using a hexagon wrench to prevent strut rod
from turning, tighten the new self-locking nut with
ST.
ST 20399AG000 STRUT MOUNT SOCKET
Tightening torque:
⋅
70 N
m (7.1 kgf-m, 51.6 ft-lb)
10) Loosen the coil spring carefully.
E: INSPECTION
Check the removed part for wear, damage and
cracks, and then repair or replace it if defective.
1. DAMPER STRUT
1) Check for oil leaks.
2) Move the piston rod up and down to check that it
operates smoothly without any hitch.
(1)
FS-00128
ST
FS-00041
Front Strut
3) Piston rod play
• Measure the play as follows:
Fix the outer shell and fully extend the rod. Set a
dial gauge at the end of rod L [10 mm (0.39 in)], and
then read the dial gauge indication P
ing a force of W [20 N (2 kgf, 4 lbf)] to threaded end.
Apply a force of 20 N (2 kgf, 4 lbf) in the opposite di-
rection of "W", and then read the dial gauge indica-
tion P
.
2
W
Play limit (P
0.8 mm (0.031 in)
If the play exceeds limit, replace the strut.
2. STRUT MOUNT
Check the rubber part for deformation, cracks or
deterioration, and then replace it with a new one if
defective.
3. DUST COVER
If any cracks or damage are found, replace it with a
new one.
4. COIL SPRING
If a permanent strain is found, replaced it with a
new one.
5. HELPER
Replace it with a new one if cracked or damaged.
F: DISPOSAL
1. EXCEPT BILSTEIN STRUT
CAUTION:
• Before handling struts, be sure to wear gog-
gles to protect eyes from gas, oil and cutting
powder.
• Do not disassemble the strut damper or place
into a fire.
• Drill a hole into struts in case of discarding
struts filled with gas.
1) Place the strut on a level surface with the piston
rod fully expanded.
FS-23
FRONT SUSPENSION
L
+ P
):
1
2
while apply-
1
FS-00046
Advertisement
Chapters
Table of Contents
