Table of Contents
Advertisement
CONTROL SYSTEMS
17) Remove the rod and spring from arm.
(C)
(A) Rod
(B) Spring
(C) Arm
D: ASSEMBLY
1) Clean all the parts before assembly.
2) Apply
grease
[KOPR-KOTE
003603001) or equivalent] to each parts. <Ref. to
CS-3, AT SELECT LEVER, COMPONENT, Gener-
al Description.>
3) Assemble in the reverse order of disassembly.
NOTE:
• When installing the guide plate, shift the select
lever to "D" range (normal mode position), care
should be taken in the following points.
(1) Insert the protrusion (B) of guide plate into
the hole of shift lock solenoid unit (A).
(2) Insert the link (D) of shift lock release into
the link (C) of shift lock solenoid unit.
b
a
b
(D)
(C)
Select Lever
(A)
(B)
CS-00383
(Part
No.
a
(B)
(A)
CS-00384
CS-26
• Connect the switch and solenoid terminal to con-
nector.
(B) (A)
1 2
5
(A) "P" range switch (Color code: Red)
(B) "P" range switch (Color code: Red)
(C) Shift lock solenoid (Color code: Black)
(D) Shift lock solenoid (Color code: Blue and Red)
(E) SPORT mode switch (Color code: White)
(F) SPORT mode switch (Color code: Black)
4) After completion of installation, shift the select
lever from "P" range to "D" range, then check
whether the indicator and select lever matches,
whether the pointer and position mark matches and
what the operating force is.
E: INSPECTION
1) Inspect the removed parts by comparing with
new ones for deformation, damage and wear. Re-
pair or replace if defective.
2) Confirm the select lever operating condition be-
fore assembly. Normal if it operates smoothly.
(D)
(C)
3 4
6
7 8
9 10
(E)
(F)
CS-00386
Advertisement
Chapters
Table of Contents
