Table of Contents
Advertisement
5) Fit one end of a vinyl tube into the air bleeder of
operating cylinder and the other end into a brake
fluid container.
6) Slowly depress the clutch pedal and keep it de-
pressed. Open the air bleeder to discharge air to-
gether with the fluid.
Release the air bleeder for 1 or 2 seconds. Next,
with the bleeder closed, slowly release the clutch
pedal.
NOTE:
Bring the air breather screw part higher than the tip
of operating cylinder when performing this proce-
dure.
(A)
(A) Operating cylinder
(B) Vinyl tube
7) Repeat these steps until there are no more air
bubbles in the vinyl tube.
CAUTION:
Cover the bleeder with waste cloth when loos-
ening it, to prevent brake fluid from being
splashed over surrounding parts.
8) Tighten the air bleeder.
Tightening torque:
⋅
8 N
m (0.8 kgf-m, 5.8 ft-lb)
9) Install the operating cylinder.
Tightening torque:
⋅
41 N
m (4.2 kgf-m, 30.2 ft-lb)
10) After depressing the clutch pedal, make sure
that there are no leaks evident in the entire system.
11) After bleeding air from the system, ensure that
clutch operates properly.
Clutch Fluid Air Bleeding
12) Install the air cleaner case. <Ref. to IN(H6DO)-
5, REMOVAL, Air Cleaner Case.>
(B)
CL-00070
CL-00068
CL-35
CLUTCH SYSTEM
Advertisement
Chapters
Table of Contents
