Table of Contents
Advertisement
26) Put the flat board weighed on retaining plate.
27) Using the following formula, calculate "N" indi-
cated on the push/pull gauge.
N = 100 N (10.2 kgf, 22.5 lbf) − Z
N: Value indicated on push/pull gauge
100 N (10.2 kgf, 22.5 lbf): Load applied to clutch
plate
Z: Flat board weight
28) Press the center of retaining plate by applying a
force of N using push/pull gauge, and then mea-
sure and record the height A. Measure at three
places or more in even distance and take the aver-
age value.
NOTE:
If three places, measure in every 120°. If four plac-
es, measure in every 90°.
A
(A) Driven plate
(B) Drive plate
(C) Retaining plate
AT Main Case
29) Install the pressure plate, drive plate, driven
plate, retaining plate and snap ring.
AT-01720
30) Install a new 2-4 brake oil seal to transmission
case.
31) After all 2-4 brake component parts have been
installed, blow in air intermittently and confirm the
operation of brake.
32) Measure the clearance B between retaining
plate and snap ring.
(C)
(B)
(A)
AT-01723
4AT-127
AUTOMATIC TRANSMISSION
AT-00254
AT-02215
AT-00290
B
AT-01724
Advertisement
Chapters
Table of Contents
