Subaru Legacy 2005 Service Manual page 2407

35.AT Main Case
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5AT-38, REMOVAL, Automatic Trans-
mission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
5AT-70, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Disconnect the air breather hose.
5) Remove the oil charge pipe. <Ref. to 5AT-69,
REMOVAL, Oil Charge Pipe.>
6) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-60, REMOVAL, ATF Filter.>
7) Remove the extension case and intermediate
case. <Ref. to 5AT-71, REMOVAL, Extension
Case and Intermediate Case.>
8) Remove the center differential carrier. <Ref. to
5AT-78, REMOVAL, Center Differential Carrier.>
9) Remove the reduction driven gear. <Ref. to 5AT-
76, REMOVAL, Reduction Driven Gear.>
10) Separate the converter case and transmission
case. <Ref. to 5AT-82, REMOVAL, Converter
Case.>
11) Remove the control valve body. <Ref. to 5AT-
58, REMOVAL, Control Valve Body.>
12) Remove the oil pump cover.
<Ref. to 5AT-84, REMOVAL, Oil Pump Cover.>
NOTE:
The input clutch pack assembly and front sun gear
assembly are also removed together.
13) Remove the needle bearing of middle carrier
assembly.
AT Main Case
14) Remove the middle carrier assembly.
15) Remove the rear carrier assembly.
AT-01990
AT-01991
5AT-97
AUTOMATIC TRANSMISSION
AT-01992
AT-01993