Subaru Legacy 2005 Service Manual page 2782

MANUAL TRANSMISSION AND DIFFERENTIAL
3. SELECTION OF 5TH-6TH FORK ROD
NOTE:
Perform the procedures below in the following cas-
es.
• When replacing the main shaft.
• When replacing the 3rd to 6th drive gear and
bushing.
• When replacing the 3rd to 6th synchro ring as-
sembly.
• When replacing the 3rd-4th hub and sleeve as-
sembly.
• When replacing the 5th-6th hub and sleeve as-
sembly.
1) Insert the main shaft assembly in adapter plate.
2) Set the height gauge to adapter plate. Lower the
indicator of height gauge to upper surface of snap
ring groove, or the upper side of main rear bearing.
Set to zero point.
ST 18853AA000 HEIGHT GAUGE
(A) Ball bearing
NOTE:
• Remove the remaining gasket on edge surface
with scraper, since the height gauge is set on
adapter plate during measurement.
• Do not place the height gauge on shaded area in
the figure during the measurement.
Shifter Fork and Rod
3) Using the height gauge, measure "D1" and "D2"
shown in the figure.
(A)
(1) Shift the 5th-6th sleeve to 6th main gear
side, then press down to the stopper and mea-
sure "D2".
MT-00706
MT-00583
6MT-120
D2
D1
(A) 5th main gear
(B) 6th main gear
(A) 6th main gear
(B)
(A)
MT-00712
(A)
MT-00713