Subaru Legacy 2005 Service Manual page 2940

DIFFERENTIALS
3) Install the selected pinion height adjusting wash-
er on drive pinion, and press the rear bearing cone
into position with ST.
ST 398177700 INSTALLER
ST
4) Insert the drive pinion into differential carrier, in-
stall the selected bearing preload adjusting collar
and washer.
(A)
(B)
(C)
(A) Drive pinion
(B) Bearing preload adjusting collar
(C) Bearing preload adjusting washer
(D) Differential carrier
5) Press-fit the front bearing cone into case with
ST1, ST2 and ST3.
ST1 398507703 DUMMY COLLAR
ST2 399780104 WEIGHT
ST3 899580100 INSTALLER
ST3
ST1
ST2
Rear Differential (T-type)
DI-00085
(D)
DI-00086
DI-00087
DI-38
6) Insert the collar, then press-fit the pilot bearing
with ST1 and ST2.
ST1 399780104 WEIGHT
ST2 899580100 INSTALLER
ST2
ST1
7) Fit a new oil seal using ST.
NOTE:
• Press-fit until end of oil seal is 1 mm (0.04 in) in-
ward from end of carrier.
• Apply grease to the oil seal lips.
ST 498447120 INSTALLER
ST
8) Press-fit the companion flange with ST1 and
ST2.
NOTE:
Be careful not to damage the bearing.
ST1 899874100 INSTALLER
ST2 399780104 WEIGHT
ST1
ST2
DI-00088
DI-00089
DI-00090