Subaru Legacy 2005 Service Manual page 2933

3) Install the ST to rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
4) Insert the spline shaft until the spline portion
comes inside the side oil seal.
5) Remove ST from rear differential.
ST 28099PA090 OIL SEAL PROTECTOR
6) Push the rear differential to insert the axle shaft
into rear differential.
7) Adjust the transmission jack, if necessary, and
insert the rear differential stud bolt into rear cross-
member bushing properly.
Rear Differential (T-type)
8) After inserting the rear differential stud bolt into
rear crossmember bushing, lift up the transmission
jack and align the rear differential with its own posi-
tion.
ST
DI-00279
9) Tighten the rear crossmember self-locking nut
temporarily.
DI-00280
10) Remove the band from rear differential. Lift up
the rear differential until the rear differential is sep-
arated from the transmission jack.
11) Install the rear differential front member.
Tightening torque:
T1: 52 N
T2: 110 N
DI-00281
DI-00393
DI-31
⋅
m (5.3 kgf-m, 38 ft-lb)
⋅
m (11.2 kgf-m, 81 ft-lb)
T2
T1
DIFFERENTIALS
DI-00283
DI-00269
DI-00284