Subaru Legacy 2005 Service Manual page 2935

4) Remove the bolts, and then remove the rear
cover.
NOTE:
Remove it by tapping with plastic hammer.
(B)
(A) Rear cover
(B) Differential carrier
5) Keep the side bearing retainers RH and LH sep-
arately for easier reassembly. Remove the side
bearing retainer attaching bolts, set the ST to differ-
ential case, and extract the side bearing retainers
RH and LH with a puller.
NOTE:
Each shim, which is installed to adjusted the side
bearing preload, should be kept together with its
mating retainer.
ST 398457700 ATTACHMENT
ST
6) Pull out the differential case assembly from dif-
ferential carrier.
NOTE:
Be careful not to hit the teeth against the case.
Rear Differential (T-type)
7) When replacing the side bearing, remove the
bearing cup from side bearing retainer using ST.
ST 398527700
(A)
8) Extract the bearing cone with ST.
DI-00063
NOTE:
• Do not attempt to disassemble the parts unless
necessary.
• Set the puller so that its claws catch the edge of
the bearing cone.
• Never mix up the bearing races RH and LH and
cones.
ST 18759AA000 PULLER ASSY
9) Remove the hypoid driven gear by loosening hy-
poid driven gear bolts.
DI-00064
10) Drive out the pinion shaft lock pin from hypoid
driven gear side (Model without LSD).
DI-00065
DI-33
DIFFERENTIALS
PULLER ASSY
ST
DI-00066
ST
DI-00316
DI-00068