Table of Contents
Advertisement
2) Insert the select lever, and then tighten the bolt.
Tightening torque:
⋅
6 N
m (0.6 kgf-m, 4 ft-lb)
3) Insert the manual plate and parking rod.
(A)
(B)
(A) Bolt
(B) Range select lever
(C) Manual plate
(D) Parking rod
4) Insert the straight pin to manual plate.
5) Install the oil pan and control valve assembly.
<Ref. to 4AT-63, INSTALLATION, Control Valve
Body.>
6) Turn over the transmission case to its original
position.
7) Install the pitching stopper bracket.
Tightening torque:
⋅
41 N
m (4.2 kgf-m, 30.4 ft-lb)
8) Install and adjust the inhibitor switch. <Ref. to
4AT-51, Inhibitor Switch.>
Transmission Control Device
AT-00308
(C)
(D)
AT-02225
AT-02224
4AT-143
AUTOMATIC TRANSMISSION
9) Insert the inhibitor switch and transmission con-
nector to stay.
(B)
(A) Transmission connector
(B) Inhibitor switch connector
10) Install the air breather hose. <Ref. to 4AT-79,
INSTALLATION, Air Breather Hose.>
11) Insert the input shaft while rotating it lightly by
hand, and then check the protrusion amount.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
12) Install the torque converter clutch assembly.
<Ref. to 4AT-81, INSTALLATION, Torque Convert-
er Clutch Assembly.>
13) Install the transmission assembly into vehicle.
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Check the manual lever and detention spring are
not worn or otherwise damaged.
(A)
AT-01351
AT-03204
Advertisement
Chapters
Table of Contents
