Subaru Legacy 2005 Service Manual page 1991

14) Disconnect the connectors, and then remove
the four bolts to take out the select lever assembly
from vehicle body.
C
A
B: INSTALLATION
1) Set the select lever assembly to vehicle body.
2) Tighten the four bolts to install the select lever to
vehicle body, and then connect the connector.
(1) Temporarily tighten the bolt A.
(2) Tighten the bolt B.
(3) Tighten the bolt A.
(4) Tighten the bolts C and D.
Tightening torque:
⋅
18 N m (1.8 kgf-m, 13.3 ft-lb)
C
A
3) Install the harness clips to the bracket.
4) Install the console front panel.
5) Install the ring indicator.
6) Install the console box. <Ref. to EI-53, INSTAL-
LATION, Console Box.>
7) Shift the select lever to "N" range.
8) Lift-up the vehicle.
9) Fix the select cable to bracket. <Ref. to CS-28,
INSTALLATION, Select Cable.>
Select Lever
10) Adjust the select cable position. <Ref. to CS-
30, ADJUSTMENT, Select Cable.>
11) After the completion of adjustment, confirm that
the select lever operates properly at all range posi-
tions.
B
12) Install the heat shield cover.
13) Install the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO 2.0)-10, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4SO 2.0)-12, IN-
D
STALLATION, Muffler.>
• DOHC non-turbo model
<Ref. to EX(H6DO)-7, INSTALLATION, Rear Ex-
CS-00580
haust Pipe.> <Ref. to EX(H6DO)-9, INSTALLA-
TION, Muffler.>
• DOHC turbo model
<Ref. to EX(H4DOTC)-11, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-12, IN-
STALLATION, Muffler.>
14) Inspect the following items. When the malfunc-
tions are found in the inspection, adjust the select
cable and inhibitor switch.
NOTE:
Inhibitor switch for 5AT model is not adjustable.
<Ref. to CS-30, ADJUSTMENT, Select Cable.>
<Ref. to 4AT-51, ADJUSTMENT, Inhibitor Switch.>
B
D
C: DISASSEMBLY
1) Remove the packing and plate.
CS-00580
CS-00372
CS-23
(1) Engine starts when the select lever is in "P"
and "N" range, but not in other range.
(2) Back-up light illuminates when the select le-
ver is in the "R" range, but not in other range.
(3) Select lever and indicator positions are
matched.
CONTROL SYSTEMS
CS-00281