Subaru Legacy 2005 Service Manual page 2385

27.Rear Drive Shaft
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5AT-38, REMOVAL, Automatic Trans-
mission Assembly.>
2) Remove the rear vehicle speed sensor, and then
remove the extension case. <Ref. to 5AT-71, RE-
MOVAL, Extension Case and Intermediate Case.>
3) Pull out the rear drive shaft from center differen-
tial assembly.
4) Remove the drive plate and driven plate.
B: INSTALLATION
1) Select the appropriate shim. <Ref. to 5AT-73,
ADJUSTMENT, Transfer Clutch.>
2) Install the drive plate and driven plate.
3) Insert the rear drive shaft into center differential
assembly.
4) Combine the extension case, and then install the
rear vehicle speed sensor. <Ref. to 5AT-71, IN-
STALLATION, Extension Case and Intermediate
Case.>
5) Install the transmission assembly into vehicle.
<Ref. to 5AT-42, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1) Using a press, remove the revolution gear.
(A) Revolution gear
Rear Drive Shaft
AT-01963
(A)
AT-00149
5AT-75
AUTOMATIC TRANSMISSION
2) Using a press, remove the front and rear side
ball bearings and clutch hub.
(A)
(A) Rear ball bearing
(B) Rear drive shaft
(C) Clutch hub
D: ASSEMBLY
Assemble in the reverse order of disassembly.
NOTE:
• Use new ball bearings and revolution gear.
• Make sure the clutch hub is oriented in the cor-
rect direction.
(A)
(A) Front side
(B) Clutch hub
(C) Rear side
(D) Revolution gear
E: INSPECTION
• Check each parts for holes, damages or other
foreign matters.
• Inspect the extension end play and adjust it to
within specification. <Ref. to 5AT-73, ADJUST-
MENT, Transfer Clutch.>
(B)
(C)
AT-00151
(B)
(C)
(D)
AT-00152