Table of Contents
Advertisement
25) Install the ST3 to lock nut, then install the ST1
and ST2 to the driven gear assembly and tighten
the lock nut.
ST1 18666AA000 HOLDER
ST2 18664AA000 BASE
ST3 18620AA000 ADAPTER WRENCH
ST4 18852AA000 TORQUE WRENCH
Tightening torque:
⋅
530 N
m (54.0 kgf-m, 391 ft-lb)
ST3
NOTE:
If torque wrench except ST4 is used, calculate the
following calculation formula, then tighten the lock
nut.
T = L1 / (0.1 + L1) × 570
T
N⋅m (kgf-m, ft-lb) Setting value of torque
L1
m (in) Torque wrench length
0.1 m (3.94 in)
570 N⋅m (58.1 kgf-m, 420 ft-lb) Tightening torque of lock
(A)
(A) 0.1 m (3.94 in)
Driven Gear Assembly
ST4
ST2
ST1
MT-00613
wrench
ST length
nut:
L1
MT-00614
MANUAL TRANSMISSION AND DIFFERENTIAL
26) Using the ST, caulk the lock nut at four points at
dimension A of 44±0.5 mm (1.73±0.02 in).
ST 18669AA000 PUNCH
NOTE:
Do not damage the caulking portion of lock nut.
6MT-89
ST
A
A
MT-00615
Advertisement
Chapters
Table of Contents
