Subaru Legacy 2005 Service Manual page 2725

5) If replacing the oil pump cover assembly, select
the transfer driven gear and thrust washer, then in-
stall them to the extension case. <Ref. to 6MT-49,
ADJUSTMENT, Extension Case.>
6) Remove the selector arm No. 2 and shifter arm.
(A)
(A) Selector arm No. 2
(B) Shifter arm
7) Install the spring pin.
NOTE:
Use new spring pin.
8) Using the ST, install the neutral set spring and
support.
ST1 18756AA000 CLAW
ST2 399893600 PLIERS
ST2 ST2
9) Install the flat washer and snap ring.
10) Install the oil guide.
(A) Oil guide
11) Install the center differential. <Ref. to 6MT-60,
INSTALLATION, Center Differential.>
Oil Pump
(B)
MT-01308
ST1
MT-01092
(A)
MT-00520
6MT-63
MANUAL TRANSMISSION AND DIFFERENTIAL
12) Install the transfer driven gear. <Ref. to 6MT-
58, INSTALLATION, Transfer Driven Gear.>
13) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
14) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: INSPECTION
1) Check that there is no damage on the inner rotor
and outer rotor. Replace the oil pump rotor assem-
bly if damaged.
2) Tip clearance
Install the inner rotor and outer rotor to transmis-
sion case. Align tip of the inner rotor and outer ro-
tor, then measure the clearance. Replace the oil
pump rotor assembly if clearance exceeds specifi-
cation.
Tip clearance specification:
Less than 0.15 mm (0.0059 in)
3) Side clearance
Measure to the transmission case and rotor. Re-
place the oil pump rotor assembly if clearance ex-
ceeds specification.
Side clearance specification:
0.03 — 0.10 mm (0.0012 — 0.0039 in)
MT-00524
MT-00525