Subaru Legacy 2005 Service Manual page 2654

Hide thumbs Also See for Legacy 2005:

Table of Contents

MANUAL TRANSMISSION AND DIFFERENTIAL

C: INSPECTION

1) Move the reverse shifter rod toward reverse

side. Inspect the clearance between reverse idler

gear and transmission case wall.

If out of specification, select an appropriate reverse

shifter lever and adjust.

Clearance A:

6.0 — 7.5 mm (0.236 — 0.295 in)

2) After installing a suitable reverse shifter lever,

shift into neutral. Inspect the clearance between re-

verse idler gear and transmission case wall.

If out of specification, select an appropriate washer

0 — 0.5 mm (0 — 0.020 in)

3) Check the reverse idler gear and shaft for dam-

age. Replace if it is damaged.

Reverse Idler Gear

D: ADJUSTMENT

1) Select an appropriate reverse shifter lever from

the table below, and adjust until the gap between

reverse idler gear and transmission case wall is

within specification.

Clearance A:

6.0 — 7.5 mm (0.236 — 0.295 in)

2) Select an appropriate washer from the table be-

low, and adjust until the gap between the reverse

idler gear and transmission case wall is within

specification.

0 — 0.5 mm (0 — 0.020 in)

Reverse shifter lever

Further from case wall

Closer to case wall

Thickness mm (in)

Chapters

Table of Contents