Subaru Legacy 2005 Service Manual page 2355

38) Connect the following connectors.
• Turbo model
(1) Transmission harness connectors
(2) Front oxygen (A/F) sensor
• Non-turbo model
(1)
(1) Front oxygen (A/F) sensor
(2) Transmission harness connectors
39) Install the intercooler stay and engine hanger
rear. (Turbo model)
Automatic Transmission Assembly
AT-01364
AT-01379
(2)
AT-02025
AT-01365
5AT-45
AUTOMATIC TRANSMISSION
40) Install the engine hanger rear, and then con-
nect the engine harness connector. (Non-turbo
model)
(A)
(A)
(A) Engine harness connectors
(B) Engine hanger rear
41) Install the water by-pass pipe. (Turbo model)
42) Pour ATF through the oil charge pipe. <Ref. to
5AT-28, REPLACEMENT, Automatic Transmis-
sion Fluid.>
43) Install the air breather hose. <Ref. to 5AT-68,
INSTALLATION, Air Breather Hose.>
44) Install the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-12, INSTALLATION, Intercooler.>
45) Install the air intake chamber. (Non-turbo mod-
el) <Ref. to IN(H6DO)-7, INSTALLATION, Air In-
take Chamber.>
46) Install the air cleaner case. (Non-turbo model)
<Ref. to IN(H6DO)-6, INSTALLATION, Air Cleaner
Case.>
47) Install the collector cover.
48) Connect the ground cable to battery.
49) Perform the Clear Memory 2. <Ref. to 5AT(di-
ag)-19, CLEAR MEMORY MODE, OPERATION,
Subaru Select Monitor.>
(1) Connect the Subaru Select Monitor to data
link connector.
(2) Turn the ignition switch to ON (engine OFF),
and turn the Subaru Select Monitor power
switch to ON.
(3) Ensure that the select lever is in "P" range.
(4) On the "Main Menu" display screen, select
the {Each System Check} and press the [YES]
key.
(B)
AT-02023
AT-01366