Subaru Legacy 2005 Service Manual page 2727

B: INSTALLATION
1) Make sure that each shifter fork and interlock
block is shifted to neutral position. If not, shift to the
neutral position.
(C)
(A) Striking rod
(B) Reverse interlock block
(C) Interlock block
2) Apply liquid gasket to the adapter plate.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
3) Install the transmission case.
Transmission Case
(A)
(B)
MT-00531
MT-00532
6MT-65
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Make sure the interlock block and reverse inter-
lock block are aligned in neutral position by inspect-
ing through the pilot bolt installation hole. If not
aligned, remove the transmission case, then shift
each shifter fork and interlock block to neutral posi-
tion.
(B)
(A)
(A) Interlock block
(B) Reverse interlock block
5) Install the pilot bolts and gasket temporarily.
NOTE:
Use a new gasket.
6) Tighten the transmission case with bolts and
nuts.
Tightening torque:
⋅
50 N m (5.1 kgf-m, 36.9 ft-lb)
7) Tighten the pilot bolts.
Tightening torque:
⋅
34 N m (3.5 kgf-m, 25.1 ft-lb)
8) Tighten the holder reverse bolt.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
MT-00533