Subaru Legacy 2005 Service Manual page 2161

2) Remove the needle bearing after taking out the
snap ring.
(A)
(A) Needle bearing
(B) Snap ring
D: ASSEMBLY
1. HIGH CLUTCH AND REVERSE CLUTCH
1) Install the seal ring and lip seal to the high clutch
piston and reverse clutch piston.
2) Install the high clutch piston to reverse clutch
piston.
(A)
(A) High clutch piston
(B) Reverse clutch piston
3) Install the reverse clutch piston to high clutch
drum. Align the groove on reverse clutch piston
with the groove on high clutch drum during installa-
tion.
(A)
(A) Reverse clutch piston
(B) High clutch drum
AT Main Case
(B)
AT-00268
(B)
AT-00240
(B)
AT-00241
4AT-133
AUTOMATIC TRANSMISSION
4) Install the spring retainer to high clutch piston.
(A)
(A) Spring retainer
(B) High clutch drum
5) Install the ST to high clutch piston.
ST 498437000 HIGH CLUTCH PISTON
GUIDE
6) Install the cover to high clutch piston in order to
prevent the high clutch piston seal from folding.
7) Install the snap ring using ST1 and ST2.
ST1 398673600 COMPRESSOR
ST2 498627100 SEAT
ST3 498437000 HIGH CLUTCH PISTON
GUIDE
8) Place the dish plate, driven plate, drive plate and
retaining plate neatly in this order on surface table.
9) Set the dial gauge to clutch, and read its scale.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
(B)
AT-00242
ST
AT-00243
ST1
ST3
ST2
AT-00244