Subaru Legacy 2005 Service Manual page 2387

3) Install the ball bearing on the reverse side with
the same procedure as step 2).
E: INSPECTION
Make sure the ball bearing and gear are not de-
formed or damaged.
F: ADJUSTMENT
1) Using a depth gauge, measure the depth "A"
from the mating surface of extension case to ball
bearing on rear end of reduction driven gear.
A
2) Using a depth gauge, measure the height "B"
from the mating surface of extension case to ball
bearing inside low part of extension case.
Reduction Driven Gear
AT-01971
AT-02090
B
AT-02091
5AT-77
AUTOMATIC TRANSMISSION
3) Calculation formula:
Select the ball bearing shim from the table to adjust
clearances within 0.05 — 0.25 mm (0.0020 —
0.0098 in).
When clearances are 0.05 mm (0.0020 in):
T (mm) = A − B + 0.23
[T (in) = A − B + 0.0091]
When clearances are 0.25 mm (0.0098 in):
T (mm) = A − B + 0.03
[T (in) = A − B + 0.0012]
T: Shim clearance
A: Depth from mating surface of extension case to
ball bearing outer ring end surface
B: Height from mating surface of extension case to
ball bearing inside low part
Reduction gear shim
Part No.
31288AA030
31288AA050
31288AA060
Thickness mm (in)
0.2 (0.008)
0.5 (0.020)
0.3 (0.012)