Subaru Legacy 2005 Service Manual page 2162

AUTOMATIC TRANSMISSION
10) Scale and record the weight "Z" of a flat board
which will be put on retaining plate.
NOTE:
• Use a stiff board which does not bend against
load as a flat board to be put on retaining plate.
• Use a flat board of its weight less than 25.5 kg
(56.2 lb).
11) Put the flat board weighed on retaining plate.
12) Using the following formula, calculate "N" indi-
cated on the push/pull gauge.
N = 250 N (25.5 kgf, 56.2 lbf)− Z
N: Value indicated on push/pull gauge
250 N (25.5 kgf, 56.2 lbf): Load applied to clutch
plate
Z: Flat board weight
AT Main Case
13) Press the center of retaining plate by applying a
force of N using push/pull gauge, and then mea-
sure and record the height A. Measure at three
places or more in even distance and take the aver-
age value.
NOTE:
If three places, measure in every 120°. If four plac-
es, measure in every 90°.
AT-01720
14) Install the thickest driven plate to piston side,
and then install the driven plate, drive plate, retain-
ing plate to high clutch drum.
15) Install the snap ring to high clutch drum.
4AT-134
A
(A) Driven plate
(B) Drive plate
(C) Retaining plate
(C)
(B)
(A)
AT-01725
AT-00245