Subaru Legacy 2005 Service Manual page 2346

AUTOMATIC TRANSMISSION
8. Transfer Clutch Pressure
Test
A: INSPECTION
1) Set the vehicle on a lift.
2) Remove the heat shield cover securing bolts to
slide the heat shield cover.
3) Remove the test plug and install the ST.
ST 498897200 ADAPTER
CAUTION:
Be careful not to cut your arm with the heat
shield cover when removing the test plug and
installing the ST.
ST
4) Set the ST1 and ST2.
ST1 498897200 ADAPTER
ST2 498575400 OIL PRESSURE GAUGE
ASSY
ST1
ST2
5) Lower the vehicle, and pull the ST into vehicle.
ST 498575400 OIL PRESSURE GAUGE
ASSY
Transfer Clutch Pressure Test
AT-01754
AT-03075
AT-03076
5AT-36
6) Connect the Subaru Select Monitor to data link
connector and read the current data. <Ref. to
5AT(diag)-17, READ CURRENT DATA, OPERA-
TION, Subaru Select Monitor.>
(1) Start the engine.
(2) Turn the Subaru Select Monitor power
switch to ON.
(3) On the "Main Menu" display screen, select
the {Each System Check} and press the [YES]
key.
(4) On the "System Selection Menu" display
screen, select the {Transmission} and press the
[YES] key.
(5) Press the [YES] key after the information of
transmission type has been displayed.
(6) On the "Transmission Diagnosis" display
screen, select the {Current Data Display&Save}
and then press the [YES] key.
(7) On the "Transmission Diagnosis" display
screen, select the {Data Display} and press the
[YES] key.
(8) Using the scroll key, display the "4WD Sole-
noid Pressure".