Subaru Legacy 2005 Service Manual page 2820

CLUTCH SYSTEM
D: ASSEMBLY
1. 5MT NON-TURBO MODEL
1) Apply a coat of grease to the contact surfaces of
the push rod and piston before installation.
Grease:
SILICONE GREASE G40M (Part No.
004404003)
2) Assemble in the reverse order of disassembly.
Tightening torque:
⋅
10 N m (1.0 kgf-m, 7.4 ft-lb)
2. 5MT TURBO MODEL AND 6MT MODEL
1) Install the clutch damper.
Tightening torque:
⋅
46.6 N m (4.75 kgf-m, 34.4 ft-lb)
2) Apply a coat of grease to the contact surfaces of
the push rod and piston before installation.
Grease:
SILICONE GREASE G40M (Part No.
004404003)
3) Assemble in the reverse order of disassembly.
Tightening torque:
⋅
10 N m (1.0 kgf-m, 7.4 ft-lb)
Master Cylinder
E: INSPECTION
If any damage, deformation, wear, swelling, rust or
other faults is found on the cylinder, piston, push
rod, fluid reservoir, return spring, gasket, clutch
damper cylinder boot or hose, replace the faulty
part.
• 5MT Non-turbo model
CL-00156
• 5MT turbo model and 6MT model
CL-00054
CL-30
(C)
(B)
(A)
(A) Master cylinder body
(B) Return spring
(C) Piston
(D) Stop ring
(E) Push rod ASSY
(F) Cylinder boot
(C)
(B)
(A)
(F)
(A) Master cylinder body
(B) Return spring
(C) Piston
(D) Stop ring
(E) Push rod ASSY
(F) Clutch damper
(G) Cylinder boot
(F)
(D)
(E)
CL-00157
(G)
(D)
(E)
CL-00056