Subaru Legacy 2005 Service Manual page 2781

NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 3rd side.
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining middle val-
ue as measurement value.
4) According to both measurements, calculate the
3rd-4th sleeve neutral position. Select the fork rod,
which applies to the calculated value from following
calculation formula.
Calculation formula: T = (C1 + C2) / 2
T: 3th-4th sleeve center position
C1: Depth measurement from main shaft rear bear-
ing snap ring groove to sleeve edge when shifted to
3rd gear: +55 mm (2.17 in)
C2: Depth from main shaft rear bearing snap ring
groove to sleeve edge when shifted to 4th gear
Shifter Fork and Rod
(2)
(1)
MT-00585
6MT-119
MANUAL TRANSMISSION AND DIFFERENTIAL
NOTE:
The indicator is installed upside down compared to
the setting procedure of zero point. Add d1 [fixing
value: 55 mm (2.17 in)] from the following figure to
"C1", to obtain measurement value of "C1".
d1
M.SFT
T
Snap ring
mm (in)
805072010
[t = 1.65 mm
(0.065 in)]
137.22 —
137.52 32809AA171
(5.4024 — (None)
5.4142)
137.52 —
137.82 32809AA161
(5.4142 — (1)
5.4260)
137.82 —
138.12 32809AA141
(5.4260 — (3)
5.4378)
T = Thickness
MT-00705
Lot No. (Mark)
M.SFT M.SFT
Snap ring Snap ring
805072011 805072012
[t = 1.95 mm [t = 2.25 mm
(0.077 in)] (0.089 in)]
32809AA181 32809AA191
(2) (4)
32809AA171 32809AA181
(None) (2)
32809AA161 32809AA171
(1) (None)