Subaru Legacy 2005 Service Manual page 2718

MANUAL TRANSMISSION AND DIFFERENTIAL
14.Transfer Drive Gear
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 6MT-34, REMOVAL, Manual
Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-40, Preparation for Overhaul.>
3) Remove the extension case. <Ref. to 6MT-47,
REMOVAL, Extension Case.>
4) Remove the transfer drive gear.
B: INSTALLATION
1) Install the transfer drive gear.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
2) If the ball bearing, transfer drive gear or snap
ring is replaced, select the transfer drive gear thrust
washer. <Ref. to 6MT-48, ASSEMBLY, Extension
Case.>
3) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
4) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
Transfer Drive Gear
C: DISASSEMBLY
1) Remove the snap ring.
2) Using the ST, remove the bearing.
ST 499877000
NOTE:
Use a new ball bearing.
MT-00505
MT-00505
6MT-56
MT-00506
RACE 4-5 INSTALLER
ST
MT-00507