Subaru Legacy 2005 Service Manual page 2700

MANUAL TRANSMISSION AND DIFFERENTIAL
11) Install the ground cable to transmission and
body.
12) Connect the engine harness connectors, and
then install the engine hanger rear.
(A) Engine harness connectors
(B) Engine hanger rear
13) Replace the front differential side retainer oil
seal.
(1) Remove the oil seal by using flat tip screw-
driver, etc.
(2) Apply gear oil to the new oil seal lips.
(3) Install a new oil seal using the ST.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
Always replace the differential side oil seal after ex-
tracting front drive shaft from the transmission.
14) Set the ST to side retainer.
ST 28399SA010 OIL SEAL PROTECTOR
Manual Transmission Assembly
MT-01266
MT-01267
(B)
(A)
MT-01302
6MT-38
15) Install the front drive shaft into transmission.
NOTE:
Replace the circlip of drive shaft with a new one.
16) Install the front drive shaft into transmission, re-
move the ST and insert the drive shaft securely.
ST 28399SA010 OIL SEAL PROTECTOR
17) Install the ball joint of front arm.
Tightening torque:
⋅
50 N m (5.1 kgf-m, 36.9 ft-lb)
18) Install the front stabilizer link.
Tightening torque:
⋅
45 N m (4.6 kgf-m, 33.2 ft-lb)
NOTE:
Use a new self-locking nut.
19) Install the heat shield cover.
20) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
21) Install the front exhaust pipe, rear exhaust pipe
and muffler. <Ref. to EX(H6DO)-5, INSTALLA-
TION, Front Exhaust Pipe.> <Ref. to EX(H6DO)-7,
INSTALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H6DO)-9, INSTALLATION, Muffler.>
22) Install the universal joint. <Ref. to PS-22, IN-
STALLATION, Universal Joint.>
23) Install the under cover.
24) Pour transmission gear oil.
<Ref. to 6MT-29, REPLACEMENT, Transmission
Gear Oil.>
25) Install the air cleaner case. <Ref. to IN(H6DO)-
6, INSTALLATION, Air Cleaner Case.>
FS-00106
FS-00117