Subaru Legacy 2005 Service Manual page 2783

NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 6th side.
• Perform the measuring procedure with two peo-
ple, and measure the sleeve lifted up straight.
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining middle val-
ue as measurement value.
(2) Set the height gauge indicator upside down.
(A)
(A) Indicator
(3) Shift the 5th-6th sleeve to 5th main gear
side, then press down to the stopper and mea-
sure "D1".
(A) 5th main gear
Shifter Fork and Rod
(2)
(1)
MT-00585
MT-00710
(A)
MT-00714
6MT-121
MANUAL TRANSMISSION AND DIFFERENTIAL
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
sleeve 5th side.
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining middle val-
ue as measurement value.
(2)
(1)
MT-00585