Subaru Legacy 2005 Service Manual page 2699

4) Install the front crossmember and rear cross-
member.
NOTE:
To facilitate installation, rotate the turn buckle of ST
(engine support) to lift up the rear side of engine.
Tightening torque:
⋅
T1: 70 N m (7.1 kgf-m, 51.6 ft-lb)
⋅
T2: 140 N m (14.3 kgf-m, 103 ft-lb)
T1
T2
5) Lower the vehicle and install the fixing bolt.
Tightening torque:
⋅
50 N m (5.1 kgf-m, 36.9 ft-lb)
6) Make sure the release bearing is installed com-
pletely.
NOTE:
• Push the release fork to operating cylinder side
until you hear a "click" sound. Pull the release fork
to engine side. Setting is completed if the release
fork does not contact case.
• Make sure the boot cover is firmly set.
Manual Transmission Assembly
T1
T2
MT-01265
MT-00466
MT-00467
6MT-37
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Install the pitching stopper bracket.
Tightening torque:
⋅
41 N m (4.2 kgf-m, 30.2 ft-lb)
8) Install the pitching stopper.
Tightening torque:
⋅
T1: 50 N m (5.1 kgf-m, 36.9 ft-lb)
⋅
T2: 58 N m (5.9 kgf-m, 42.8 ft-lb)
T2
9) Install the clutch operating cylinder.
Tightening torque:
⋅
41 N m (4.2 kgf-m, 30.2 ft-lb)
NOTE:
Check that the clutch hose is routed properly.
10) Install the starter assembly. <Ref. to SC(H4SO
2.0)-6, INSTALLATION, Starter.>
T1
MT-01281
MT-01268