Table of Contents
Advertisement
5) Tighten the plug.
Tightening torque:
⋅
44 N
m (4.5 kgf-m, 32.5 ft-lb)
6) Check the release bearing and release lever for
smooth movement by operating the release lever.
7) Install the transmission assembly. <Ref. to 6MT-
36, INSTALLATION, Manual Transmission Assem-
bly.>
C: INSPECTION
1. RELEASE BEARING
CAUTION:
Since this bearing is grease-sealed and non-lu-
brication type, do not wash with gasoline or any
other solvent when servicing clutch.
1) Check the bearing for smooth movement by ap-
plying force to the bearing in radial direction.
Radial direction stroke:
1.6 mm (0.063 in)
(A)
(A) Bearing case
Release Bearing and Lever
2) Check the bearing for smooth rotation by apply-
ing force to the bearing in thrust direction.
CL-00031
3) Check for wear or damage on the bearing case
surface which contacts lever.
2. RELEASE LEVER
Check the pivot and the contact area with release
bearing case in the lever for wear.
CL-00032
CL-25
(A)
(A) Bearing case
(B)
(C)
(A) Release lever
(B) Pivot
(C) Release bearing
CLUTCH SYSTEM
CL-00160
(A)
CL-00034
Advertisement
Chapters
Table of Contents
