Subaru Legacy 2005 Service Manual page 2784

MANUAL TRANSMISSION AND DIFFERENTIAL
4) According to both measurements, calculate the
5th-6th sleeve neutral position. Select the fork rod,
which applies to the calculated value from following
calculation formula.
Calculation formula: T = (D1 + D2) / 2
T: 5th-6th sleeve center position
D1: Length from the shaft rear bearing snap ring
groove to sleeve groove edge when shifted to 5th
gear [Measurement +55 mm (2.17 in)]
D2: Length from main shaft rear bearing snap ring
groove to sleeve groove edge when shifted to 6th
gear
NOTE:
The indicator is installed upside down compared to
the setting procedure of zero point. Add d1 [fixing
value: 55 mm (2.17 in)] from the following figure to
"D1", to obtain measurement value of "D1".
d1
M.SFT
T
Snap ring
mm (in)
805072010
[t = 1.65 mm
(0.065 in)]
64.12 —
64.42 32945AA021
(2.5244 — (None)
2.5362)
64.42 —
64.72 32945AA011
(2.5362 — (1)
2.5480)
64.72 —
65.02 32945AA001
(2.5480 — (3)
2.5598)
T = Thickness
Shifter Fork and Rod
MT-00705
Lot No. (Mark)
M.SFT M.SFT
Snap ring Snap ring
805072011 805072012
[t = 1.95 mm [t = 2.25 mm
(0.077 in)] (0.089 in)]
32945AA031 32945AA041
(2) (4)
32945AA021 32945AA031
(None) (2)
32945AA011 32945AA021
(1) (None)
6MT-122
4. SELECTION OF REVERSE FORK ROD
NOTE:
Perform the procedures below in the following cas-
es.
• When replacing the reverse idler gear.
• When replacing the reverse idler gear No. 2.
• When replacing the adapter plate.
• When replacing the base.
1) Insert the reverse idler gear assembly in adapter
plate.
2) Tighten the base COMPL fixing bolt.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
3) Set the height gauge to adapter plate. Lower the
indicator of height gauge to mating surface of
adapter plate and case, then set to zero point.
ST 18853AA000 HEIGHT GAUGE
ST
MT-00546
MT-00582