Subaru Legacy 2005 Service Manual page 2349

13) Remove the water by-pass pipe. (Turbo model)
14) Separate the torque converter from drive plate.
(1) Remove the service hole plug.
(2) Remove the bolts which hold torque con-
verter to drive plate.
(3) Remove the four bolts by rotating the clamp
pulley a little at a time.
(4) Make sure the torque converter moves free-
ly by rotating with finger through the starter in-
stallation hole.
CAUTION:
Be careful not to drop bolts into converter
housing.
15) Install the ST to converter case.
ST 498277200 STOPPER SET
16) Lift-up the vehicle.
17) Remove the under cover. (Non-turbo model)
18) Remove the front exhaust pipe, rear exhaust
pipe and muffler. (Non-turbo model) <Ref. to
EX(H6DO)-4, REMOVAL, Front Exhaust Pipe.>
<Ref. to EX(H6DO)-7, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H6DO)-9, REMOVAL, Muffler.>
Automatic Transmission Assembly
AT-01366
AT-01367
ST
AT-00103
5AT-39
AUTOMATIC TRANSMISSION
19) Remove the ATF cooler inlet and outlet pipes.
(Non-turbo model) <Ref. to 5AT-63, REMOVAL,
ATF Cooler Pipe and Hose.>
20) Remove the pitching stopper.
21) Remove the pitching stopper bracket.
22) Set the ST.
ST 41099AC000 ENGINE SUPPORT ASSY
(Turbo model)
ST 41099AA010 ENGINE SUPPORT BRACK-
ET (Non-turbo model)
ST 41099AA020 ENGINE SUPPORT (Non-tur-
bo model)
23) Remove the air intake duct. (Turbo model)
<Ref. to IN(H4DOTC)-9, REMOVAL, Air Intake
Duct.>
24) Remove the air cleaner case. (Turbo model)
<Ref. to IN(H4DOTC)-8, REMOVAL, Air Cleaner
Case.>
25) Remove the linear motion mounting. (Turbo
model) <Ref. to ME(H4DOTC)-38, REMOVAL, Lin-
ear Motion Mounting.>
AT-01368
AT-01369
AT-01370