Subaru Legacy 2005 Service Manual page 2117

5) Install the snap ring to ST.
ST 499257300 SNAP RING OUTER GUIDE
(A)
(B)
(A) Snap ring
(B) Transfer clutch
6) Install the snap ring to rear drive shaft using ST1
and ST2.
ST1 499257300 SNAP RING OUTER GUIDE
ST2 499247400 INSTALLER
(A)
(A) Snap ring
(B) Transfer clutch
7) Install the driven plate, drive plate, pressure
plate and snap ring.
(A)
(A) Snap ring
Transfer Clutch
8) Apply compressed air to make sure if the assem-
bled parts move smoothly.
ST
AT-00136
9) Check the clearance between snap ring and
pressure gauge. <Ref. to 4AT-90, INSPECTION,
Transfer Clutch.>
10) Press-fit new ball bearing using ST.
ST 899580100
ST2
ST1
(B)
AT-00137
11) Apply vaseline to seal ring and install to the
seal ring groove of shaft.
NOTE:
While installing the seal ring, do not expand it ex-
cessively.
AT-00138
4AT-89
AUTOMATIC TRANSMISSION
INSTALLER
(A) Ball bearing
(A)
(A) Seal ring
(B) Transfer clutch
AT-00139
ST
(A)
AT-00140
(B)
AT-00141