Subaru Legacy 2005 Service Manual page 2152

AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Install the low & reverse brake piston.
NOTE:
• Be careful not to damage the lip seal.
• Apply ATF to lips.
2) Install the return spring.
3) Install the spring retainer.
4) Install the one-way clutch inner race, spring re-
tainer and return spring.
AT Main Case
5) Tighten the socket bolts evenly from the rear
side of transmission case.
Tightening torque:
25 N
AT-00300 6) Place the front side of transmission body up.
7) Install the thrust needle bearing.
8) Place the dish plate, driven plate, drive plate and
retaining plate neatly in this order on surface table.
9) Set the dial gauge to clutch, and read its scale.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
10) Scale and record the weight "Z" of a flat board
which will be put on retaining plate.
NOTE:
• Use a stiff board which does not bend against
AT-00301
load as a flat board to be put on retaining plate.
• Use a flat board of its weight less than 8.5 kg
(18.7 lb).
11) Put the flat board weighed on retaining plate.
AT-00302
12) Using the following formula, calculate "N" indi-
cated on the push/pull gauge.
N = 83 N (8.5 kgf, 18.7 lbf) − Z
N: Value indicated on push/pull gauge
83 N (8.5 kgf, 18.7 lbf): Load applied to clutch plate
Z: Flat board weight
4AT-124
⋅
m (2.5 kgf-m, 18.4 ft-lb)
AT-00296
AT-01720