Subaru Legacy 2005 Service Manual page 2634

MANUAL TRANSMISSION AND DIFFERENTIAL
17.Input Shaft Assembly
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 5MT-30, REMOVAL, Manual
Transmission Assembly.>
2) Remove the transfer case with extension case
assembly. <Ref. to 5MT-43, REMOVAL, Transfer
Case and Extension Case Assembly.>
3) Remove the transmission case. <Ref. to 5MT-
55, REMOVAL, Transmission Case.>
4) Remove the drive pinion shaft assembly. <Ref.
to 5MT-76, REMOVAL, Drive Pinion Shaft Assem-
bly.>
5) Remove the main shaft assembly and input shaft
assembly.
B: INSTALLATION
1) Install the needle bearing onto the front of trans-
mission main shaft assembly.
2) Connect the main shaft assembly and input shaft
assembly.
3) Install the transmission case knock pin into nee-
dle bearing outer race knock pin hole.
4) Install the drive pinion assembly. <Ref. to 5MT-
76, INSTALLATION, Drive Pinion Shaft Assem-
bly.>
5) Install the transmission case. <Ref. to 5MT-57,
INSTALLATION, Transmission Case.>
6) Install the transfer case with extension case as-
sembly. <Ref. to 5MT-43, INSTALLATION, Trans-
fer Case and Extension Case Assembly.>
7) Install the manual transmission assembly on the
vehicle. <Ref. to 5MT-32, INSTALLATION, Manual
Transmission Assembly.>
Input Shaft Assembly
C: DISASSEMBLY
1) Remove the O-ring from input shaft holder. Also,
remove the input shaft holder shim.
NOTE:
• Use a new O-ring.
• Number of shims used varies from zero to two.
2) Put a vinyl tape around the input shaft splines to
protect oil seal from damage.
3) Remove the inner snap ring.
ST 398663600
4) Hold the input shaft holder stationary and re-
move the input shaft by tapping its end with a plas-
tic hammer.
5MT-72
( B )
( A )
( C )
(A) Input shaft holder
(B) O-ring
(C) Input shaft holder shim
PLIERS
S T
( B ) ( A )
(A) Input shaft holder
(B) Input shaft
MT-00226
MT-00227
MT-00228