Subaru Legacy 2005 Service Manual page 2115

30.Transfer Clutch
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 4AT-39, REMOVAL, Automatic Trans-
mission Assembly.>
2) Remove the extension case, and then remove
the transfer clutch. <Ref. to 4AT-83, REMOVAL,
Extension Case.> <Ref. to 4AT-84, DISASSEM-
BLY, Extension Case.>
B: INSTALLATION
1) Select the thrust needle bearing. <Ref. to 4AT-
90, ADJUSTMENT, Transfer Clutch.>
2) Install the transfer clutch assembly to case.
(A)
(B)
(A) Transfer clutch
(B) Extension case
3) Tighten the bolts to secure the case.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
4) Install the transmission assembly into vehicle.
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
Transfer Clutch
C: DISASSEMBLY
1) Remove the seal ring.
2) Remove the ball bearing using ST and press.
ST 498077600
AT-00125
3) Remove the snap ring, and then take out the
pressure plate, drive plate and driven plate.
AT-00118
4AT-87
AUTOMATIC TRANSMISSION
(A) Seal ring
(B) Transfer clutch
REMOVER
(A) Snap ring
(B) Transfer clutch
AT-00127
AT-00128
AT-00129