Subaru Legacy 2005 Service Manual page 2717

5) Set the ST1 to reverse check shaft. Install a new
oil seal, then press with ST2.
ST1 18671AA000 OIL SEAL GUIDE
ST2 18657AA010 INSTALLER
(A)
(A) Oil seal
6) Insert the reverse check lever, then rotate the re-
verse check shaft until the plunger can be pushed.
(A) Plunger
(B) Reverse check shaft
7) Align the hole of reverse check lever and reverse
check shaft, then install the spring pin.
(A)
(A) Reverse check shaft
(B) Reverse check lever
(C) Hole
8) Make sure the reverse check operates correctly.
<Ref. to 6MT-55, INSPECTION, Reverse Check
System.>
9) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
Reverse Check System
ST2
ST1
MT-00500
(A)
(B)
MT-00501
(C)
(B)
MT-00502
MANUAL TRANSMISSION AND DIFFERENTIAL
10) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: INSPECTION
1) Check there is no damage on each part.
2) Check that the reverse check lever operates
smoothly.
3) Check that there is no oil leakage on oil seal part
of reverse check shaft. If there is oil leakage, re-
place the oil seal.
4) Inspect the reverse check operation.
(1) The plunger can be pushed or the gear can
be shifted to reverse, when reverse check lever
is in the following position.
(2) The plunger cannot be pushed or the gear
cannot be shifted to reverse, when reverse
check lever is in the following position.
5) If not as specified, reassemble the reverse
check system.
6MT-55
MT-00503
MT-00504