Subaru Legacy 2005 Service Manual page 2707

11.Neutral Position Switch
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 6MT-34, REMOVAL, Manual
Transmission Assembly.>
2) Disconnect the neutral position switch connector
and clip.
(A)
(C)
(B)
(A) Back-up light switch connector (White)
(B) Neutral position switch connector (Black)
(C) Clip
3) Remove the neutral position switch.
(A) Back-up light switch
(B) Neutral position switch
Neutral Position Switch
(C)
MT-00471
(A)
(B)
MT-00472
MANUAL TRANSMISSION AND DIFFERENTIAL
B: INSTALLATION
1) Install the neutral position switch.
NOTE:
Use a new gasket.
Tightening torque:
⋅
32 N m (3.3 kgf-m, 23.6 ft-lb)
(A) Back-up light switch
(B) Neutral position switch
2) Connect the neutral position switch connector
and clip.
(A)
(B)
(A) Back-up light switch connector (White)
(B) Neutral position switch connector (Black)
(C) Clip
3) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
6MT-45
(A)
(B)
MT-00472
(C)
(C)
MT-00471