Table of Contents
Advertisement
3) Remove the bushing and spacer from plate as-
sembly.
(A)
(A) Bushing
(B) Spacer
4) Remove the bushing from plate assembly.
D: ASSEMBLY
1) Assemble in the reverse order of disassembly.
Tightening torque:
⋅
12 N
m (1.2 kgf-m, 8.9 ft-lb)
NOTE:
For the area to be applied with grease, refer to
"COMPONENT". <Ref. to CS-3, COMPONENT,
General Description.>
2) Make sure the select lever moves smoothly.
E: INSPECTION
1) Check that the select lever moves smoothly. If it
does not move smoothly, check the transmission
and drive select lever.
2) Check that HI and LO are switched properly. If
they do not switched properly, adjust the drive se-
lect cable and inspect the transmission.
3) Check that the drive select lever for damage.
Repair or replace if it is damaged.
MT Drive Select Lever
(B)
(A)
CS-00399
CS-00400
CS-57
CONTROL SYSTEMS
Advertisement
Chapters
Table of Contents
