Subaru Legacy 2005 Service Manual page 2027

14) Loose the nut, and then remove the cable from
cable bracket.
15) Lift-up the vehicle, and then remove the cable
under vehicle.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• Adjust the drive select cable. <Ref. to CS-59,
ADJUSTMENT, Drive Select Cable.>
• Refer to "COMPONENT" for tightening torque.
<Ref. to CS-3, COMPONENT, General Descrip-
tion.>
• Securely insert the cable end bolt to slit of lever
arm.
C: INSPECTION
1) Check the transmission is set in HI or LO posi-
tion according to the operation of drive select lever.
If it is not set to HI or LO, adjust the cable. <Ref. to
CS-59, ADJUSTMENT, Drive Select Cable.>
2) Check cable for damage.
3) Check for smooth operation of the cable. If it
does not move smoothly, replace it.
D: ADJUSTMENT
1) Set the drive select lever to "HI" position.
Drive Select Cable
2) Push the both sides of knob and remove the cov-
er. (Rubber type)
CS-00404
3) Insert a screwdriver with thin tip into the both
sides of knob and push to remove the cover.
(Leather type)
4) Remove the bolts, and then remove the knob.
5) Remove the console box. <Ref. to EI-53, RE-
MOVAL, Console Box.>
6) Loosen the flange nut.
CS-00405
7) Verify the transmission gear is set in HI position.
If not in HI position, pull the cable to set it in HI po-
sition.
8) Verify the select lever is set in HI position.
9) Tighten the flange nut with cable fixed.
Tightening torque:
12 N
10) Install in the reverse order of removal.
CS-59
(A)
(A) Cover
(B) Knob
⋅
m (1.2 kgf-m, 8.9 ft-lb)
CONTROL SYSTEMS
(B)
CS-00395
CS-00401