Subaru Legacy 2005 Service Manual page 2168

AUTOMATIC TRANSMISSION
19) Install the needle bearing, and then secure with
the snap ring.
(A)
(A) Needle bearing
(B) Snap ring
20) Install the one-way clutch, and then secure with
snap ring.
21) Set the one-way clutch inner race. Make sure
that the clutch locks in the clockwise direction and
rotates in the counterclockwise direction.
(A)
(A) Lock
(B) Rotate
3. 2-4 BRAKE
1) Apply ATF to D-ring, and then install it to 2-4
brake piston.
2) Install 2-4 brake piston to 2-4 brake piston re-
tainer.
( A )
(A) 2-4 brake piston
(B) 2-4 brake piston retainer
AT Main Case
(B)
AT-00268
(B)
AT-00282
( B )
AT-00288
4AT-140
4. ONE-WAY CLUTCH INNER RACE
1) Install the needle bearing to inner race using ST
and press.
ST 398497701 SEAT
2) Apply vaseline to the groove of inner race and
seal ring.
3) Install two seal rings to one-way clutch inner
race.
(A) One-way clutch inner race
(B) Seal ring
5. ONE-WAY CLUTCH OUTER RACE
1) Install the needle bearing, and then secure with
the snap ring.
(A)
(A) Needle bearing
(B) Snap ring
2) Install the one-way clutch and one-way clutch in-
ner race, and then secure with snap ring.
ST
AT-00299
(A)
(B)
AT-00298
(B)
AT-00268