Subaru Legacy 2005 Service Manual page 2821

7. Clutch Pipe and Hose
A: REMOVAL
1) Remove the air intake chamber. (Non turbo
model) <Ref. to IN(H4SO 2.0)-7, REMOVAL, Air In-
take Chamber.>
2) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-12, REMOVAL, Intercooler.>
3) Drain the clutch fluid. <Ref. to CL-33, Clutch Flu-
id.>
4) Disconnect the clutch pipe from the clutch hose
and master cylinder.
5) Pull out the clamp, then remove the clutch hose
from bracket.
(B)
(A) Clamp
(B) Clutch hose
6) Disconnect the hose from operating cylinder.
7) Remove the bracket.
Clutch Pipe and Hose
(A)
CL-00057
CL-31
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Bleed air in the clutch fluid. <Ref. to CL-34, Clutch
Fluid Air Bleeding.>
• 5MT model
Tightening torque:
⋅
T1: 15 N m (1.5 kgf-m, 10.8 ft-lb)
⋅
T2: 18 N m (1.8 kgf-m, 13.0 ft-lb)
⋅
T3: 25 N m (2.5 kgf-m, 18.4 ft-lb)
T1
T3
(B)
(C)
(C)
T2
(A) Clutch pipe (LHD model)
(B) Clip
(C) Clutch hose
(D) Clutch pipe (RHD model)
CLUTCH SYSTEM
T1
(A)
T1
(D)
T1
T3
(C)
(B)
CL-00283