Subaru Legacy 2005 Service Manual page 2859

7. Front Strut
A: REMOVAL
1) Lift-up the vehicle, and then remove the front
wheels.
2) Put an alignment mark on the camber adjusting
bolt and strut.
3) Remove the bolt securing brake hose from strut.
4) Remove the bolt securing ABS wheel speed
sensor harness.
5) Remove the two bolts securing housing to strut.
NOTE:
While holding the head of adjusting bolt, loosen the
self-locking nut.
Front Strut
6) Remove the three nuts securing strut mount to
body.
FS-00037
B: INSTALLATION
1) Install the strut mount at the upper side of strut to
body, and tighten it with new self-locking nuts.
Tightening torque:
20 N
2) Align alignment marks on the camber adjusting
FS-00038
bolt and strut.
Using new self-locking nuts, install the strut to
housing.
NOTE:
While holding the head of adjusting bolt, tighten the
self-locking nut.
Tightening torque:
175 N
3) Secure the ABS wheel speed sensor harness to
strut.
Tightening torque:
33 N
4) Install the bolts which secure brake hose to strut.
Tightening torque:
33 N
5) Install the front wheels.
NOTE:
Inspect the wheel alignment and adjust if neces-
sary.
FS-21
FRONT SUSPENSION
⋅
m (2.0 kgf-m, 14.5 ft-lb)
⋅
m (17.8 kgf-m, 129 ft-lb)
⋅
m (3.4 kgf-m, 24.3 ft-lb)
⋅
m (3.4 kgf-m, 24.3 ft-lb)
FS-00039