Subaru Legacy 2005 Service Manual page 2779

(4) According to both measurements, calculate
the 1st-2nd sleeve neutral position. Select the
fork rod, which applies to the calculated value
from following calculation formula.
Calculation formula: T = (B1 + B2) / 2
T: 1st-2nd sleeve center position
B1: Height from adapter plate edge to sleeve
edge when shifted to 1st gear
B2: Height measurement from adapter plate
edge to sleeve edge when shifted to 2nd gear:
+55 mm (2.17 in)
NOTE:
The indicator is installed upside down compared to
the setting procedure of zero point. Add d1 [fixing
value: 55 mm (2.17 in)] from the following figure to
"B2", to obtain measurement value of "B2".
d1
T mm (in)
62.93 — 63.23
(2.4776 — 2.4894)
63.23 — 63.53
(2.4894 — 2.5012)
63.53 — 63.83
(2.5012 — 2.5130)
Shifter Fork and Rod
MT-00705
Lot No. (Mark)
32801AA111 (1)
32801AA131 (None)
32801AA141 (2)
6MT-117
MANUAL TRANSMISSION AND DIFFERENTIAL
2. SELECTION OF 3RD-4TH FORK ROD
NOTE:
Perform the procedures below in the following cas-
es.
• When replacing the main shaft.
• When replacing the 3rd, 3rd to 6th drive gear and
bushing.
• When replacing the 3rd, 3rd to 6th synchro as-
sembly and bushing.
• When replacing the 3rd-4th hub and sleeve as-
sembly.
1) Insert the main shaft assembly in adapter plate.
2) Set the height gauge to adapter plate. Lower the
indicator of height gauge to upper surface of snap
ring groove, on the upper side of main rear bearing,
then set to zero point.
ST 18853AA000 HEIGHT GAUGE
(A) Loller bearing
NOTE:
• Remove the remaining gasket on edge surface
with scraper, since the height gauge is set on
adapter plate during measurement.
• Do not place the height gauge on shaded area in
the figure during the measurement.
(A)
MT-00706
MT-00583