Subaru Legacy 2005 Service Manual page 2188

AUTOMATIC TRANSMISSION (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to 4AT(diag)-6, PREPARATION TOOL, Gen-
eral Description.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's side).
(1) Data link connector
Subaru Select Monitor
(2) Connect the diagnosis cable to data link
connector.
NOTE:
Do not connect scan tools except Subaru Select
Monitor.
5) Turn the ignition switch to ON (engine OFF), and
turn the Subaru Select Monitor power switch to ON.
AT-00338
6) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
7) On the «System Selection Menu» display
screen, select the {Transmission} and press the
[YES] key.
8) Press the [YES] key after the information of
transmission type is displayed.
9) On the «Transmission Diagnosis» display
screen, select the {Diagnosis Code(s) Display} and
press [YES] key.
NOTE:
• For details concerning operation procedure, re-
fer to the SUBARU SELECT MONITOR OPERA-
AT-00339
TION MANUAL.
• For details concerning DTC, refer to "List of Diag-
nostic Trouble Code (DTC)". <Ref. to 4AT(diag)-
31, List of Diagnostic Trouble Code (DTC).>
2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
(1)
2) On the «System Selection Menu» display
screen, select the {Transmission} and press the
[YES] key.
3) Press the [YES] key after the information of
transmission type is displayed.
4) On the «Transmission Diagnosis» display
screen, select the {Current Data Display & Save}
AT-01712
and press the [YES] key.
5) On the «Transmission Diagnosis» display
screen, select the {Data Display} and press the
[YES] key.
6) Using the scroll key, scroll the display screen up
or down until the desired data is shown.
4AT(diag)-16
(A) Power switch
(A)
AT-00341