Subaru Legacy 2005 Service Manual page 2130

AUTOMATIC TRANSMISSION
37.Converter Case
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 4AT-39, REMOVAL, Automatic Trans-
mission Assembly.>
2) Pull out the torque converter clutch assembly.
<Ref. to 4AT-81, REMOVAL, Torque Converter
Clutch Assembly.>
3) Remove the input shaft.
4) Lift up the lever on rear part of connector, and
then disconnect it from stay.
5) Disconnect the inhibitor switch connector from
stay.
(B)
(A) Transmission connector
(B) Inhibitor switch connector
6) Remove the oil charge pipe. <Ref. to 4AT-80,
REMOVAL, Oil Charge Pipe.>
7) Remove the oil cooler inlet and outlet pipes.
<Ref. to 4AT-68, REMOVAL, ATF Cooler Pipe and
Hose.>
8) Remove the converter case aligning bolt, and
then separate the transmission case and converter
case by lightly tapping with plastic hammer.
NOTE:
• Be careful not to damage the oil seal and bush-
ing of converter case inside by oil pump cover.
Converter Case
• Be careful not to loosen the rubber seal.
9) Remove the seal pipe.
AT-00114
(A)
10) Remove the differential assembly. <Ref. to
4AT-115, REMOVAL, Front Differential Assem-
bly.>
11) Remove the oil seal from converter case.
B: INSTALLATION
1) Check the appearance of each component and
clean them.
2) Press-fit the oil seal to converter case using ST.
AT-01351
ST 398437700
3) Install the differential assembly to case. <Ref. to
4AT-115, INSTALLATION, Front Differential As-
sembly.>
4) Install the left and right side retainers. <Ref. to
4AT-119, ADJUSTMENT, Front Differential As-
sembly.>
4AT-102
(A) Seal pipe
DRIFT
AT-03203
AT-00176
AT-00177