Subaru Legacy 2005 Service Manual page 2338

AUTOMATIC TRANSMISSION
2. Automatic Transmission Flu-
id
A: INSPECTION
NOTE:
The level of ATF varies with fluid temperature. Pay
attention to the ATF temperature when checking
ATF level.
1) Raise the ATF temperature by driving a distance
of 5 to 10 km (3 to 6 miles). Otherwise, idle the en-
gine to raise ATF temperature to 70 — 80°C (158
— 176°F) on Subaru Select Monitor. <Ref. to
5AT(diag)-17, READ CURRENT DATA, OPERA-
TION, Subaru Select Monitor.>
2) Park the vehicle on a level surface.
3) After selecting all positions (P, R, N, D), set the
select lever in "P" range. Measure the ATF level
with engine idling for one or two minutes.
(B)
(C)
(A) ATF level gauge
(B) Upper level
(C) Lower level
4) Make sure that ATF level is above the center be-
tween upper and lower marks at HOT side.
5) If the ATF level is below the center between up-
per and lower marks, add the recommended ATF
until the fluid level is found above the center be-
tween upper and lower marks.
CAUTION:
• Use care not to exceed the upper level.
• When the transmission is cold, be careful not
to add ATF to the upper level on HOT side.
Overfilling of ATF may cause oil splashing.
6) Raise the ATF temperature by driving a distance
of 5 to 10 km (3 to 6 miles). Otherwise, idle the en-
gine to raise ATF temperature to 70 — 80°C (158
— 176°F) on Subaru Select Monitor. <Ref. to
5AT(diag)-17, READ CURRENT DATA, OPERA-
TION, Subaru Select Monitor.>
7) Check the ATF for leaks.
Visually check for leaks in the transmission. If there
are leaks, replace the gasket, oil seal, plug or other
parts.
Automatic Transmission Fluid
(A)
(B)
(C)
AT-00674
5AT-28
B: REPLACEMENT
1) Lift-up the vehicle.
2) Remove the ATF drain plug to drain ATF.
CAUTION:
Directly after the vehicle has been running, the
ATF is hot. Be careful not to burn yourself.
3) Check the condition of ATF.
<Ref. to 5AT-29, CONDITION CHECK, Automatic
Transmission Fluid.>
4) Tighten the ATF drain plug.
NOTE:
Use a new gasket.
Tightening torque:
⋅
20 N m (2.0 kgf-m, 14.8 ft-lb)
(B)
(A) Oil pan
(B) ATF drain plug
5) Lower the vehicle.
6) Pour ATF from the oil charge pipe.
Specified fluid:
SUBARU ATF (Part No. K0140Y0700)
Recommended fluid:
IDEMITSU ATF HP
Castrol Transmax J
NOTE:
Use of recommended fluid is permitted only on the
area where the specified fluid is not available.
Capacity:
Fill the same amount of ATF when drained.
Capacity when transmission is overhauled:
9.6 — 10.0 2 (10.1 — 10.6 US qt, 8.4 — 8.8 Imp
qt)
7) Check the level and leaks of ATF.
<Ref. to 5AT-28, INSPECTION, Automatic Trans-
mission Fluid.>
(A)
AT-03126