Subaru Legacy 2005 Service Manual page 2831

9) Tighten the push rod lock nut.
Tightening torque:
⋅
10 N m (1.0 kgf-m, 7.4 ft-lb)
10) Depress and release the clutch pedal two or
three times to ensure that clutch pedal and release
lever operate smoothly. If the clutch pedal and re-
lease lever do not operate smoothly, bleed air from
the clutch system. <Ref. to CL-34, Clutch Fluid Air
Bleeding.>
11) Measure the clutch pedal full stroke length
again to ensure that it is within specifications. If it is
not within the specified range, repeat the adjust-
ment procedure from the beginning.
Specified clutch pedal full stroke:
Non-turbo model
130 — 135 mm (5.12 — 5.31 in)
Turbo model
135 — 140 mm (5.31 — 5.51 in)
12) Move the clevis pin to the left, then to the right.
The clevis pin should move without resistance
while it is rattling. If resistance is felt, repeat the ad-
justment procedure again from the beginning.
13) Push the release lever until operating cylinder
push rod retracts. Ensure that the clutch fluid level
in reservoir tank increases. If the clutch fluid level
increases, clutch is adjusted correctly. If the fluid
level does not increase or push rod does not re-
tract, replace the master cylinder with new one.
<Ref. to CL-28, Master Cylinder.>
• 2.0 L Non-turbo model and Turbo model
(3)
(1) Push rod
(2) Release lever
(3) Operating cylinder
Clutch Pedal
(2)
(1)
CL-00227
CL-41
• 3.0 L model
(2)
(1)
(1) Push rod
(2) Release lever
(3) Operating cylinder
14) Push the release lever until operating cylinder
push rod retracts. Check that the clutch fluid level in
reservoir tank increases.
• 2.0 L Non-turbo model and Turbo model
(3)
(1) Push rod
(2) Release lever
(3) Operating cylinder
• 3.0 L model
(2)
(1)
(1) Push rod
(2) Release lever
(3) Operating cylinder
15) If the clutch fluid level increases, clutch play is
adjusted correctly.
CLUTCH SYSTEM
(3)
CL-00402
(2)
(1)
CL-00227
(3)
CL-00402