Subaru Legacy 2005 Service Manual page 1995

4. Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Disconnect the ground cable from battery.
4) Lift-up the vehicle.
5) Remove the front, center and rear exhaust pipes
and muffler. (SOHC and DOHC non-turbo model)
• SOHC model
<Ref. to EX(H4SO 2.0)-6, REMOVAL, Front Ex-
haust Pipe.> <Ref. to EX(H4SO 2.0)-9, REMOVAL,
Center Exhaust Pipe.> <Ref. to EX(H4SO 2.0)-10,
REMOVAL, Rear Exhaust Pipe.>
EX(H4SO 2.0)-12, REMOVAL, Muffler.>
• DOHC non-turbo model
<Ref. to EX(H6DO)-4, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H6DO)-7, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H6DO)-9, REMOVAL,
Muffler.>
6) Remove the center exhaust pipe, rear exhaust
pipe and muffler. (DOHC turbo model)
<Ref. to EX(H4DOTC)-6, REMOVAL, Center Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-11, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4DOTC)-
12, REMOVAL, Muffler.>
7) Remove the heat shield cover.
8) Remove the snap pin and washer from range se-
lect lever.
Select Cable
• 4AT
<Ref. to
• 5AT
AT-01331
9) Remove the plate assembly from transmission
case.
• 4AT
CS-27
(A)
(D)
(C) (E)
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Bracket
(E) Washer
(B)
(D)
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Bracket
(E) Washer
( A )
( C )
( B )
(A) Select cable
(B) Plate ASSY
(C) Bracket
CONTROL SYSTEMS
(B)
CS-00036
(E)
(A)
(C)
CS-00327
CS-00037